BOB B-740 115V | BOBRICK Eclipse® Surface-Mounted Hand Dryer With White Vitreous Enamel Cover
Bobrick Eclipse® Surface-Mounted Hand Dryer: shall have a one-piece, deep-drawn steel cover with white vitreous enamel finish.
- Motor shall be 1/10 hp, universal type with sealed ball bearing at drive end and self-lubricating sleeve bearing at non-drive end; equipped with automatic thermal-overload switch.
- Heating element shall be located on inlet side of fan, shall heat air without hot spots, be inaccessible to vandals and equipped with automatic thermal-overload switch. - Electronic sensor shall automatically turn dryer on when hands are held under air-outlet opening and across path of sensor.
- Dryer will turn off automatically when hands are removed.
- Sensor shall automatically shut dryer off approximately 1-1/2 minutes after dryer turns on if an inanimate object is placed across air-outlet opening.
- After inanimate object is removed, electronic sensor shall automatically reset itself and dryer shall operate normally.
- Unit shall be cULus Listed (208-240V, AC Models, also VDE approved, CE marked).
- Unit shall comply with EU Directive “Restriction of Hazardous Substance” (ROHS) requirements for non-use of certain hazardous substances in the production of
electronic products.
- Unit shall be protected by a limited 10-year warranty on all parts except motor brushes.
- Motor brushes shall be warranted for three years from date of purchase.
- Automatic sensor,115V AC, 20 Amp, 2300 Watts, 50/60 Hz, cULus Listed.

Operation:
No-touch Operation: electronic sensor automatically turns dryer on when hands are held under air-outlet opening and across path of sensor. Remove hands and dryer stops. Dryer will not stop by itself before user is satisfied hands are dry.
Dryer operates only when actually drying hands which saves energy and operating costs.
Electronic sensor will automatically shut dryer off 1-1/2 minutes after dryer turns on if an inanimate object, such as tape or chewing gum, is placed across air-outlet opening.
After inanimate object is removed, electronic sensor automatically resets itself and dryer operates normally.

Wiring Instructions:
- For B-740 115V and B-748 115V Dryers — Connect ground wire to ground terminal marked , the black or hot wire to the terminal marked L, and neutral or white wire to the terminal marked N. A DEDICATED LINE IS REQUIRED FOR EACH 115 VOLT Installation.