ASI 94696 | ASI Recessed Roll Paper Towel Dispenser and Waste Receptacle
American Specialty Recessed Roll Paper Towel Dispenser and Waste Receptacle: shall hold and dispense one 8" diameter (Ø203) x 8" or 9" (203/229) wide standard towel roll up to 800 feet (244m) long and one stub roll up to 4" diameter (Ø102) and shall have a waste capacity of 10.5 gallons (40 liters).
- A lever operated dispensing mechanism shall be supplied.
- Towel dispensing opening shall have a fully deburred edge for snag free dispensing and user safety.
- Full-face door, cabinet, dispenser and waste receptacle shall be fabricated of type 304 stainless steel alloy 18-8.
- All exposed surfaces shall have a No 4 satin finish and shall be protected during shipment with PVC film easily removable after installation.
- Cabinet and frame shall be fabricated of 20 gauge type 304 stainless steel alloy 18-8 with 1" (25.4) wide perimeter trim to lay flat against wall.
- Full-face door shall be 16 gauge and shall be free of miters, welding or open seams with 3/4" (19) radiused vertical edges and 15/16" (24) square horizontal returns to wall.
- Door shall be attached to the edge of unit with a concealed full length 3/16" diameter (Ø4.8) heavy duty stainless steel multi-staked piano hinge and shall be held closed with two (2) flush rimless tumbler locks keyed alike to other ASI washroom equipment.
- Unit back plate for mechanism shall be fabricated of 18 gauge.
- Interior waste receptacle shall be fabricated of stainless steel and shall have a welded on finger pull for ease of service removal and maintenance safety.
- Structural assembly of all components shall be of welded construction.

Installation:
Install unit in wall recess with four (4) No 10 self-tapping screws (by others) through concealed mounting holes provided. Note
that top of Rough Wall Opening (RWO) is 3/4" (19) below top of unit. For compliance with ICC/ANSI A-117.1-2003 and
ADA Accessibility Guidelines, install unit so that towel dispenser feed lever is 48" (1219) maximum above finished floor (MAX
AFF) only if clear floor forward reach or side reach access is provided. Be advised that local codes may require mounting so that
top of towel dispenser feed lever is 40" (1016) MAX AFF (e.g. California UBC/Title 24). For general utility install unit with
centerline of towel dispenser feed lever between 49" and 56" (1245 to 1422) AFF.
RWO required is 14-5/8" W x 39-3/4" H x 9-1/8" D

Operation:
Towels are fed by lever action. Towel feed length is adjustable for economy by pin (supplied) limiting of lever stroke length.
Unit may be reloaded with a full roll to automatically start when finished with an existing partial roll and will continue to feed
properly when reloaded with a full roll and partial roll is transferred to stub roll position. Refill dispenser by unlocking door
and replacing towel roll for an empty or partially empty unit. Dispenser supply is replenished and waste container is emptied
manually on cycles determined by maintenance needs. Locking full-face door over compartments prevents unauthorized
access or removal.