ASI 7311-24B | ASI Surface Mounted Bright Towel Shelf with Drying Rod
American Specialty Surface Mounted Bright Towel Shelf with Drying Rod: shall be fabricated of stainless steel alloy 18-8, type 304.
- Wall mounting plates shall be formed for strength with dimpled mounting holes.
- Cross tubes shall be 3/8" diameter (Ø10mm) and shall be held in receiver holes in continuous 3/4" diameter (Ø19mm) formed mounting frame mechanically retained in wall plates.
- Drying rod below shelf shall be 3/4" diameter (Ø19mm) formed tube mechanically retained in wall plates.
- 24" Length

Installation:
Surface mount unit on wall using No 8 flat or oval head self tapping screws (by others) through countersunk holes provided in mounting plate into suitable prepared mountings (by others) or other suitable mounting hardware (by others) to suit wall conditions.
- For compliance with ICC/ANSI A-117.1-2003 and ADA Accessibility Guidelines install unit with top of shelf 48" (1219mm) maximum above finished floor (MAX AFF) if clear floor forward reach or if clear floor side reach access only is provided or 46" (1168mm) MAX AFF if side reach access over an obstruction (e.g. vanity) with reach depth greater than 10" (254mm) and less than 25" (635mm) is only provided or 44" (1118mm) MAX AFF if forward reach over an obstruction (e.g. commode) with reach depth greater than 20" (508mm) and less than 25" (635mm) is only provided.
- For general utility install 68" (1727mm) MAX AFF.