ASI 3401-42P | ASI 42" Peened Grab Bar with Flanges for Exposed Mounting
American Specialty Peened Grab Bar with Flanges for Exposed Mounting For 3400 Series: shall be type 304 stainless steel alloy 18-8. Tubing shall be 1-1/4" diameter (?32) x 18 gauge [0.048"] (1.2).
- Flange shall be 11 gauge 1/8" (3) thick and shall be Heliarc welded to tubing with a continuous concealed bead.
- Flanges shall have three (3) countersunk 9/32" diameter (?7) holes to accommodate 1/4" diameter [?6] pan head or ¹ 10 self-tapping flat head or oval head mounting screws (not provided).
- All exposed surfaces shall have a satin finish and shall be protected during shipment with a plastic bag.
- 42"

Strength:
- ASI Grab Bars are designed to meet and exceed ADA requirements as published in CABO/ANSI A117.1 and 2010 ADA Accessibility Standards.
- Mounting to the wall is a critical part of the system to meet this requirement.
- To withstand the shear, tension or pullout, and torsion loads generated by the maximum loading, the fastener system must be adequately sized.

Installation:
Use grab bar as template to mark mounting holes locations and pre-drill holes. Install bar using three (3) ¹ 10 self-tapping flat head or oval head screws (by others) or other fastener system (by others) to suit conditions for each flange.
- Appropriate anchoring and backing must be provided in accordance with local building codes or as specified on Architects Plans prior to wall finishing.
- For compliance with 2010 ADA Accessibility Standards install unit so that the top of the grab bar is 33" (840) minimum above finished floor (AFF) to 36" (915) maximum
AFF.
- Anchors are available from ASI and must be specified separately for each grab bar style scheduled (see 3900 series).