ASI 7309-24B | ASI Surface Mounted Bright Towel Shelf
American Specialty Surface Mounted Bright Towel Shelf: shall be fabricated of stainless steel alloy 18-8, type 304.
- Shelf posts shall be 1/2" x 1" (13mm x 25mm) rectangular tubing with formed mounting flange and bracket welded on end.
- Cross tubes shall be 3/8" diameter (Ø10mm) and shall be held in receiver holes in support posts.
- Mounting plates shall be included and shall be 18 gauge.
- Stainless steel setscrews shall be provided on bottom perimeter of flanges to lock unit to mounting plates.
- 24" Length
- Bright Finish

Installation:
- Surface mount unit on wall using No 10 self tapping screws (by others) through holes provided in mounting plates into suitable prepared mountings (by others) or other suitable mounting hardware (by others) to suit wall conditions.
- Hang post and flange assemblies on mounting plates and tighten setscrews to lock unit to plates.
- For compliance with ICC/ANSI A-117.1-2003 and ADA Accessibility Guidelines install unit with top of shelf 48" (1219mm) maximum above finished floor (MAX AFF) if clear floor forward reach or if clear floor side reach access only is provided or 46" (1168mm) MAX AFF if side reach access over an obstruction (e.g. vanity) with reach depth greater than 10" (254mm) and less than 25" (635mm) is only provided or 44" (1118mm) MAX AFF if forward reach over an obstruction (e.g. commode) with reach depth greater than 20" (508mm) and less than 25" (635mm) is only provided.
- For general utility install shelf with centerline of mounting plates at 68" (1727mm) AFF.