ASI 64676-2 | ASI Semi Recessed Paper Towel Dispenser and Waste Receptacle
American Specialty Semi Recessed Paper Towel Dispenser and Waste Receptacle: shall hold and dispense 800 standard multi-fold, 600 standard C-fold or 1100 standard single-fold paper towels, and shall have a waste capacity of 7 gallons (26.5 liters).
- An adjustable guide shall be provided to allow dispensing of single-fold, multi-fold or C-fold paper towels.
- Cabinet, door, dispenser and waste receptacle shall be fabricated from type 304 stainless steel alloy 18-8.
- All exposed surfaces shall have a No 4 satin finish and shall be protected during shipment by PVC film easily removable after installation.
- Cabinet shall be 20 gauge with a 1" (25.4) wide perimeter trim to lay flush against wall and shall have no exposed fastening devices or visible seams.
- Full-face door shall be 18 gauge, fabricated from one piece with no miters or seams on face and shall have 1/2" (13) square returns to the wall.
- Door shall be attached to cabinet body with a full length 3/16" diameter (Ø4.8) stainless steel multi-staked piano hinge and shall be held closed with two (2) tumbler locks keyed alike to other ASI washroom equipment.
- Towel dispensing slot shall have a fully hemmed-in rolled edge for snag-free dispensing and user safety.
- Waste container shall have hemmed edges for safety.
- Structural assembly of all components shall be of welded construction.
- Waste receptacle door shall be attached to cabinet with a springloaded stainless steel piano hinge and shall have the international waste symbol on face.
- Wall Opening: 11 1/2" x 53 1/2" x 6 1/4"

Installation:
- Unit is mounted in wall recess with four (4) No 10 self-tapping screws (by others) through mounting holes in cabinet.
- For compliance with ADA Accessibility Guidelines, install unit so that center line of towel dispenser slot is 54" (1372mm) maximum above finished floor (AFF) if clear floor side reach access is provided or 48" (1219mm) maximum AFF if clear floor forward reach access only is provided.
- For general utility the unit should be installed with its bottom edge 16-3/4" (425mm) AFF.
- Note that bottom of RWO is 3/4" above bottom of unit. SR collar is installed on cabinet prior to mounting in wall recess following procedure described on SR Collar Data Sheet.

Operation:
- Towels are self-feeding until supply is depleted. Unit may be reloaded with a partial load in-place and will continue to feed properly.
- Waste receptacle is emptied manually on a cycle determined by maintenance needs.
- Locking door prevents unauthorized access or removal.